Hot cutting saw blade quality circular saw disc for hot cut of
beams, bars and billets
Hot Saw cutting blades for the Steel Cutting Industry are used in
stationary or flying cut off applications at mills with continuous
casters, hot rolling mills for billets, rails, structural sections,
and tube mills with temperatures of the product exceeding 750
degrees C / 1385 degrees F.
Hot Saws are available from 530mm to 2500mm with the standard
slaughter tooth or the V tooth with out flat part as well as
customized tooth profiles to suit the customers’ requirements. The
hot saw cutting blade requires a copious flow of coolant under high
pressure that is directed into the teeth to essentially clear the
debris from the tooth gullets and keep it clean and cool with every
The blades are available in a wide selection of carbon steel
grades, manganese steel grades and special alloy component steels
depending on the applications.
Typically, the hot saw blade is surface ground flat with parallel
sides or taper ground to a hub for additional side clearance in
cutting large profiles. Straighten and tension the hot saw blades
for each unique cutting application will also demonstrate the
quality that is built into every new blade by providing the cutting
performance that can be measured and effectively reduce the cost of
The hot saw is provided with a normalized or tempered body but
often can be supplemented with electrode hardened tooth. The teeth
are electrode hardened by contacting the edge through a red hot
graphite electode at a controlled speed and quenched to achieve a
harden cutting edge which gives considerable increased blade life
between re sharpening.
Blade material: used quality tool steel, 45Mn2V, 50Mn2V 65Mn,
51Mn7, 46Mn as saw body material.
It is characterized by good comprehensive mechanical property, high
hardness and abrasive resistance at the tip of tooth.
Tooth hardness 50-55HRC.
Tooth forms/tooth geometry:
30/30 degree pendulum tooth
|Diameter(mm)||Bore Hole(mm)||Thickness(mm)||No. of Teeth|